Static discharge in a fab, server room or pharma plant is a six-figure problem. Our ESD-rated epoxy floors give you measured surface resistivity to 10⁴–10⁹ Ω, certified per IEC 61340-5-1 and ANSI/ESD S20.20.
Server halls, MDF/IDF rooms, switching. Tier III & IV facilities — Dubai, Doha, Abu Dhabi.
PCB assembly, semicon back-end, EMS. Compliant with IEC 61340-5-1.
Cleanrooms, dispensing, fill-finish. EU GMP-compliant low-VOC, antibacterial.
Avionics, weapons, ammunition handling. Secure-zone certified applicators.
OT, ICU, MRI rooms. Low-VOC, antibacterial, conductive grades.
Solvent storage, blending, paint shops where ignition risk exists.
We test surface resistivity (point-to-point and point-to-ground) using a Megger ESD-meter on a 1 m² grid, against IEC 61340-2-3 / ASTM F150. Hand-over includes a stamped test report.
Conductive (10⁴–10⁶ Ω) for data centres, server halls, ammunition and where any static is a critical risk. Dissipative (10⁶–10⁹ Ω) for general electronics, OT, pharma — gentler discharge, kinder to equipment.
Yes — copper earth strips at 6 m centres on the substrate, all bonded to the building earth bar. Certificates of resistivity issued at hand-over.
Free site visit anywhere in Qatar or the UAE. Tell us a postcode and a rough area — we'll be on-site this week.